Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Driveway & Pavers: The Santa Clarita Owner’s Guide
Replacing ActiveYards driveway gates, gate posts, or paver-edge hardware in Santa Clarita typically runs $700 – $4,800 installed, depending on whether it’s a hinge kit, a full gate panel, or post-mount hardware tied into an existing paver driveway. Most ActiveYards gate and paver hardware we stock on the truck can be matched and swapped the same visit once we confirm the model series and post size. The way most homeowners find us: a gate that’s started dragging across the pavers, a post that’s listing after a rainy winter, or hinges that have worn to the point the gate won’t latch on the strike plate.
Elmstead Remodeling Santa Clarita is an independent service provider. We’re not affiliated with ActiveYards, but we work with their gate and fence hardware regularly, and we keep common hinge, latch, and post-mount parts in stock for the series we see most across Santa Clarita: the American Series, the Craftsman Series, and the Manhattan Series, along with their matching paver-mounted post kits.
Which ActiveYards Models This Applies To
ActiveYards builds driveway gates and fencing in three main series, and the hardware is not freely interchangeable between them. The American Series uses a 2-inch square post profile with a heavier wall than the Craftsman Series, whose posts run 2 inches as well but with a narrower interior channel for the hinge bracket. The Manhattan Series is the one that trips people up: it uses a 2.5-inch post, and a Manhattan hinge kit will not bolt correctly onto an American Series post without an adapter plate, which is available but adds cost. Check for a label or stamped code on the inside of the post cap or on the hinge plate itself. If the label is gone, measure the post width and the bolt-hole spacing before ordering anything.
For paver installations specifically, ActiveYards offers post-mount hardware designed to be anchored into a concrete footing poured below the paver line. The failure point is almost never the post itself. It’s the hinge assembly, the self-closing mechanism, or the anchor bracket where the post base meets the footing. We stock OEM ActiveYards hinge kits for the American and Craftsman series, and for older or discontinued gate runs we’ll source a quality aftermarket equivalent, matched to the original bolt pattern and gate weight rating. Our default position is this: if the gate is still under manufacturer warranty, OEM is the right call. If it’s a 12-year-old gate and the budget matters, a well-matched aftermarket hinge kit often costs 30 – 40% less and performs the same. We’ll show both options on the written quote before any work starts.
Styles & brands we work with
Signs Your ActiveYards Driveway & Pavers Is Failing
- The gate drags or scrapes across the paver surface. This usually means the hinge bushings have worn out or the gate has settled from a shifting post footing. Left alone, the bottom rail scores the pavers and the hinge pins oval out the bracket holes, so the repair bill grows from a hinge kit to a full gate re-hang plus paver repair.
- The gate won’t stay closed or latched. The self-closing tension mechanism inside the hinge body loses its spring force over time, especially in Santa Clarita’s heat, where the internal grease can dry and the spring metal fatigues faster than in coastal air. Sometimes it’s adjustable; sometimes the hinge needs replacing.
- The post leans toward the gate. That’s a footing failure, not a post failure, and it’s the most common thing we see after a wet winter in neighborhoods like Valencia and Stevenson Ranch. The concrete below the paver line cracks, the post shifts, and the gate geometry goes with it.
- Visible rust at the hinge or latch points. Santa Clarita’s dry summers keep surface rust rare, but sprinkler overspray hitting the same hinge for five years will do it. Once the powder coat is breached at the pivot pin, wear accelerates.
- Paver settlement around the post base. If the pavers around the post have dropped a half-inch or more, the base material below them is eroding, and the post anchor is working itself loose. The gate still opens, but the entire assembly is slowly rotating out of plumb.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s where ActiveYards driveway and paver hardware in Santa Clarita typically lands, installed:
- Hinge kit replacement (single gate): $700 – $1,600
- Hinge kit replacement (double gate with drop rod): $1,200 – $2,400
- Post replacement with new footing, set into existing paver driveway: $1,800 – $3,600
- Full gate panel replacement, American or Craftsman Series: $2,000 – $4,800
- Paver removal and reset around post base: $800 – $2,000
What drives the range: whether we’re swapping parts on an existing solid post or digging a new footing, whether the pavers around the base need to come out and go back, and whether the gate is a single or double panel with a drop rod. Every quote we write is a fixed, written price that includes parts, labor, the clean-up, and the haul-away of the old hardware. It does not change after the crew arrives. The work carries our 365-Day Done Right Promise: if the gate sags, the latch won’t hold, or the post shifts within a year, we come back and make it right.
DIY or Call Us?
Here’s the honest split. You can safely check a few things yourself: measure the post width and hinge bolt spacing, note which way the gate swings, and take photos of the label or hinge plate if you can find one. That information alone lets us bring the right parts on the first trip. What we’d caution against: loosening or removing gate hinges without support blocks under the gate panel. A driveway gate in motion carries real weight, and when the last hinge pin drops, that panel can swing or fall faster than you expect. We’ve seen pinched fingers and cracked paver edges from exactly that. Post removal and re-footing also requires cutting into the paver base without collapsing the surrounding pavers, which is slower work than people expect. If the gate is sagging, dragging, or leaning, call us at (661) 542-4056 and we’ll walk you through what we’re seeing in the photos before we schedule anything.
FAQs
With proper footing and normal use, the gate panel and posts on ActiveYards driveway gates in Santa Clarita typically hold up 15 – 20 years, while hinge kits and self-closing mechanisms usually need attention every 7 – 10 years because the internal springs and bushings wear from repeated cycles and dry heat. Sprinkler overspray and unsealed pavers shorten that. Call (661) 542-4056 if your gate is approaching that age and starting to drag or saggy.
Sometimes, if the hinge is just out of adjustment and the internal spring is still intact, a technician can re-tension the self-closing mechanism and replace the bushings. If the bracket holes have ovaled or the spring has fractured, replacement is the only option that will hold. We’ll show you the difference on the written quote. Call (661) 542-4056 for an exact quote.
Most hinge and latch replacements on a single ActiveYards driveway gate take 2 – 3 hours on site. A post replacement with new footing typically takes a full day plus overnight cure time before the gate is re-hung. The price on the paper is the price on the invoice – we put that in writing before the first board goes down.
We stock common ActiveYards hinge kits, latches, and post-mount hardware for the American and Craftsman series on our trucks, and we can source Manhattan Series and discontinued-model parts within a few days, usually faster than a homeowner ordering retail. We’ll tell you on the first call whether it’s an in-stock part or a special order. Call (661) 542-4056 to schedule a free estimate.
If you also need work on other parts of the property while we’re out, we keep cabinet and surfacing parts for KraftMaid, Cambria, and Silestone projects as well, and the same cleaned-up, written-price standard applies to every job we take in Santa Clarita. Graham Stein can walk you through what’s on the shelf and what makes sense for your gate and pavers before anything gets scheduled.
Written by Graham Stein, Owner, Elmstead Remodeling Santa Clarita at Elmstead Remodeling Santa Clarita, serving Santa Clarita and nearby areas.
